the location of ejection pins is usually specified
in the mold design, since these points have visible
marks (therefore ejection is usually done from the
core side, and is usually mounted into the mold half
mounted on the moving platen).
The cavity is divided between the two mold halves in
such a way that natural shrinkage of the molding
causes the part to stick to the moving half
Çıkarma pimlerinin konumu genellikle kalıp tasarımında belirtilir, çünkü bu noktalarda
görünür
işaretler bulunur (bu nedenle çıkarma genellikle çekirdek tarafından yapılır ve genellikle hareketli plaka üzerine monte edilmiş kalıp yarısına
yerleştirilir).
Boşluk, kalıplamanın doğal büzülmesinin parçanın hareketli yarıya yapışmasına neden olacak şekilde iki kalıp yarısı arasında bölünür.