Once the link is made, the ID code is stored in the receiver and no further linking is necessary unless the receiver is to be used with another transmitter. When you purchase another R0EH, this procedure is necessary; otherwise the receiver will not work.
0) Place the transmitter and the receiver close to each other within 0 meter.
0) Connect CH0(R0EH) to ESC.
0) Press and hold ID SET switch of the receiver one second, now the indicator LED will starting blinking. It will automatically find the nearest transmitter to bind.
0) Test with servo to make sure the binding is finished.
0.0.0 S-BUS, PPM and PPM signal change
Short press the ID SET switch two times within 0 second, the signal is changed from normal PWM to S-BUS or PPM. The green LED indicates the normal PWM and redgreen LED indicates S-BUS or PPM signal.
0.0.0 Transmitter calibration:
0. Press rudder trimmer left and turn on transmitter at the same time, red and green LED flashing.
0) End point calibration:
Push two sticks from the highest position to the lowest position, and then put sticks to the center