Dear Workshop and Ugras,
As we inspected at the Gifo cooler, the female holes are NOT drilled correct. At the moment clinker will not fall down to under grate compartment!
I know the female and male length can vary 0-0,0 mm during casting, but then we have to use the attached fixture, so that we find the correct centerline of the each part, and use the center line to make the hole position.
Kindly find attached the tool which automatically can center our seals before drilling.
Kindly also find attached drawing with updated position of the dimensions. Nothing is changed in the position of the holes!
Regards
Fons
Değerli Atölye ve Uğraş,
biz Gifo soğutucusu denetlenebiliyordu gibi, dişi delikler doğru delinmiş DEĞİLDİR. Şu anda klinker ızgara gözününAltına aşağı düşmeyecek!
I döküm sırasında 0-0,0 mm değişebilir kadın ve erkek uzunluğu biliyoruz ama sonra delik konumunu yapmak için her bir bölümünün doğru merkez bulmak ve böylece, bağlı kilitlerini kullanın ve merkez hattı kullanmak zorunda .
Lütfen otomatik delme önce mühürler ortalayabilmek aracı ekte bulabilirsiniz.
Lütfen, aynı zamanda boyutları güncelleştirilmiş konumu ile çizim ekte. Hiçbir şey deliklerinin pozisyonunda değiştirilir!
Selamlar
Fons